該評估套件可讓設計人員快速評估AT73C240的音頻能力，并進行原型設計和測試新的設計。單機板便于利用示范軟件產(chǎn)品評估,。

基本特性：

The AT73C240 is a fully integrated, low-cost, combined stereo audio DAC and audio power amplifier circuit targeted for Li-Ion or Ni-Mh battery powered devices such as mobile phones, smartphones, PDA, DECT phones, digital still cameras, music players or any other type of handheld device where an audio interface is needed.

Stereo Audio DAC

– 2.7V to 3.3V Analog Supply Operation

– 2.4V to 3.3V Digital Supply Operation

– 20-bit Stereo Audio DAC

– 90 dB SNR Playback Stereo Channels

– 32 Ohm/20 mW Stereo Headset Drivers with Master Volume and Mute Controls

– Stereo Line Level Input with Volume Control/Mute and Playback through the Headset Drivers

– Accepts Mixed Signals from All Signal Paths (Line Inputs and DAC Output)

– 8, 11.024, 16, 22.05, 24, 32, 44.1 and 48 kHz Sampling Rates

– 256x or 384xFs Master Clock Frequency

– I2S Serial Audio Interface

• Mono Audio Power Amplifier

– Supply Input from Main Li-Ion Battery (3V to 5.5V)

– 440 mW on 8 Ohm Load

– Programmable Volume Control (-22 to +20 dB)

– Fully Differential Structure, Input and Output

– 8 mA Drain Current in Active Mode

– Power-down Mode (Consumption Less than 2 μA)

– Minimum External Components (Direct Connection to the Loudspeaker)

• Applications: Mobile Phones, Digital Cameras, PDAs, SmartPhones, DECT Phones,Music Players

方案描述：

The evaluation kit lets designers quickly evaluate the audio capability of the AT73C240 and to prototype and test new designs. The standalone board allow easy product evaluation using demonstration software. Two serial interfaces (serial peripheral interface and I²S via a dedicated connector) boost its demonstration capabilities.

The AT73C240-EK1 provides the following features:  

Power supply: – AC/DC transformer input (6V to 9V) – or External Power Supply pad ???On-board resources: – 20-bit stereo audio DAC, – 90dB SNR playback stereo channels, – 1 stereo 32 Ohm/20mW stereo headset (3.5mm jack connector), – 1 speaker 8 Ohms output (3.5mm jack connector), – 1 line stereo input (2 RCA) ???Serial interfaces: – SPI (by default), – TWI (by hardware modification), – I²S ???On-board buttons: – AT73C240 Reset, – SPI/TWI Communication, – TWI Address selection

參考原理圖：


原理圖1



                                      原理圖2

參照PCB圖：



                                    PCB圖1



                                        PCB 圖2



                                           PCB圖3